G Save Economiser

The average household energy bill in 2004 was £560 and by 2019 it is set to be a staggering £4,500

The average gas bill today is approx £900. If a g-save were fitted to the system, and it saved, say, 20%, the household would see a payback in 12-16 months.

The new g-save Economiser so you can reduce your heating bills by up to 31%

Whether your home and hot water is heated by gas, oil or LPG, the g-save could save you ££££s and reduce your gas bills.

With the average annual home gas bill now at £1,300, now is the time to consider fitting this 'green box' to your heating/hot water system to lower your gas bills and reduce energy consumption. The g-save was tested by Good Housekeeping Magazine (February 2009), where savings were 31% during the week tested.Good House Keeping Magazine monitored the gas consumption of a four-bedroom house for two weeks, with and without the g-save. Gas consumption was 31% lower in the g-save week, which would work out at a saving of £165 over a year if it was maintained.

The g-save is a tried-and-tested, patented product that uses 'smart' technology to optimize the operation of your central heating boiler, improving efficiency to greatly reduce gas consumption and lower heating bills.

The G Save Unit is Supplied,Fitted and Commisioned For £216.00

How it Works

The g-save has two electronic timers which pulse at different pre-set times 24 hours a day, seven days a week. One timer is wired into the room thermostat wiring and the other is wired into the hot water cylinder thermostat wiring.

In a standard domestic system there is a time lag in the heating process. The time lag is caused because the thermostat demands heat from the boiler and the boiler responds, but it takes time for the heat to get around the system, and for the thermostat to register that the water or room is now hot enough. The thermostat then stops demanding heat; but the heat that is already in the system still has to work through. In effect, because of this time-lag, the water or room is overheated.

The g-save economiser pulses the demand for heat so that the latent heat in the system that is still moving around is used to full effect, even when the boiler is not active.

The g-save, once installed, cuts gas consumption by, on average, 22% making it a great way to reduce heating bills. You can look forward to lower utility bills as well as reduced CO2 emissions from your boiler. If all the 13 million gas-fuelled homes in the UK had the economizer fitted, and if they reduced their fuel consumption by only 20%, that would cut emissions by 8.5 million tonnes of CO2 every year!

The g-save is guaranteed to make a saving of at least 10%.

Click Here to Read Frequently Asked Questions About G Save

The G Save Unit is Supplied,Fitted and Commisioned For £216.00